11-43. 11-44. Using a 1.2M, 5.25-inch drive to write data on a 5.25-inch, 360K disk that was originally created in a 360K disk drive will result in what problem, if  any? 1. The 1.2M drive will not write on the 360K d i s k 2. The 360K disk will not fit into the 1.2M d r i v e 3. The 1.2M drive will write a narrow track through the wider track on the 360K disk, which could result in read errors 4. None; no problem will be encountered Formatting a 5.25-inch, 360K DSDD disk as a 1.2M HD disk will result in what problem, if any? 1. The disk will not format because the DOS format program will check the media indicator on the disk and not permit the operation 2. The disk will appear to format correctly, but will be unreliable because of the increased write current required for high density disks 3. The disk will appear to format correctly, but will be unreliable because of the decreased write current required for high density disks 4. None; no problem will be encountered 11-45. Formatting a 720K DSDD, 3.5-inch floppy disk as a 1.44M will result in what problem, if any? 1. The disk will not format because the DOS format program will check the media indicator on the disk and not permit the operation 2. The disk will appear to format correctly, but will be unreliable because of the increased write current required for high density disks 3. The disk will appear to format correctly, but will be unreliable because of the decreased write current required for high density disks 4. None; no problem will be encountered 11-46. A high-density disk can be used in a low- density drive with no problems. 1.   True 2.   False 11.-47. 11-48. 11-49. 11-50. 11-51. The drive select jumper on a floppy disk drive’s electronics card is used to select which of the following functions? 1. Drive type 2. Drive density 3. Drive address 4.  Drive  operating  speed When installing a floppy drive with a straight two-drive daisy chain cable, you should (a) connect Drive A to what connector and (b) set the drive select jumper to what drive? 1.  (a)  End (b)   DS0 2.  (a)  End (b)   DS1 3.   (a)   Middle   (b)   DS0 4.   (a)   Middle   (b)   DS1 The twist in a floppy disk cable was designed for which of the following reasons? 1. To ease floppy drive installation by setting all drives to DS1 2. To ease floppy drive installation by setting all drives to DS0 3. To ease floppy drive installation by setting drive A to DS0 and drive B to DS1 The twist in a floppy drive cable cross connects which of the following pins? 1.  10  through  16  only 2. 10 through 20 3.  20  through  26  only 4. 20 through 30 The terminating resistor on a floppy drive (a) is used to supply the proper load to what device and (b) should be connected on the floppy disk at what point on the cable? 1. (a) Computer (b)  middle 2. (a) Computer (b)  end 3.  (a)  Disk  controller  (b)  middle 4.  (a)  Disk  controller  (b)  end 78