optimizing the CPU’s time, so the CPU is not involved
in all transactions, including the I/O instructions. We
cover those methods later in this topic. However, for
computers that have an IOC, the IOC is a processor in
its own right. we focus our discussion of I/O
instructions on I/O processors with an IOC. An IOC is
capable of executing its own set of instructions
specifically designed to govern I/O operations for those
channels/ports handled by the particular IOC. Figure
7-10 shows the format of an example IOC instruction.
This format is used for some mainframes and some
minis. The designators shown are for a typical I/O
instruction and may vary with IOC instructions. Each
IOC executes instructions stored in main memory in the
same manner as the CPU executes instructions. There
are two basic types of IOC instructions: command
instructions and chaining instructions.
Command instructions are executed by the IOC
under the control of the CPU’s main program. Chaining
instructions are executed under the command of an
active channel (I/O operation in progress) chain. Some
IOC instructions perform. the same functions whether it
is a command or a chaining instruction.
Command Instructions
Command instructions provide control over IOC
single or dual channel operations. They are executed
individually using the following process. The CPU
executes an I/O command start instruction, which is
a CPU instruction. The I/O command start instruction
specifies or addresses an IOC(s) and then halts further
CPU processing. The addressed IOC then references
specific main memory addresses (the command cell)
and executes the IOC command instruction previously
stored in the addresses. At completion of the instruction
execution, the IOC will clear assigned bits of the
command cells to indicate to the CPU that the command
has been processed and to release the CPU to continue
further processing. This is one instance in interrupt
driven I/O operations where the CPU will delay
processing while waiting for an I/O operation to take
place.
The instruction contained in the command cell will
cause the IOC to perform a variety of channel activity
functions. The most common operations deal with
initiating a new chain or terminating a chain in progress.
Other commands are used to master clear individual
channels, enable or disable a variety of interrupts,
monitor channel status, load or store control memory,
and initiate the IOC built-in test (BIT).
Chaining Instructions
Chains of IOC instructions are stored in memory by
the main CPU program before the I/O operation takes
place. The actual execution of chaining instructions is
independent of the CPU. Only a command instruction
execution from the command cell will delay CPU
processing.
There can be an input chain and/or an
output chain being executed for each channel. Input or
output chains deal primarily with the transfer of blocks
of information.
A chain consists of IOC control words, command
words, output data words, and specified locations for
Figure 7-10.—IOC instruction format.
7-10
