ASSIGNMENT 1
1-1. Without the use of reports and an
accountability system, maintenance and repair
would be almost impossible.
1.
True
2.
False
1-2.
Which of the following reports must be
completed before a ship gets underway?
1.
Eight O’Clock report
2.
Twelve O’Clock report
3.
Equipment status report
4.
Casualty report
1-3.
Which of the following conditions would
require you to initiate a casualty report?
1.
Your ship needs fuel.
2.
Your ship needs to do an UNREP
3.
Your ship is anchoring
4.
Your FC radar needs a part not on board
1-4.
Which of the following reports is an initial
casualty report?
1.
CASREP
2.
CASCOR
3.
CASCAN
4.
CASCON
1-5.
Which of the following publications gives
guidance on the preparation and submission of
a casualty report?
1.
OPNAVINST 4790.4
2.
NWP 1.03.1 (IC-1)
3.
NAVSEA OP 3565
4.
SPCCINST 4441.170
1-6.
Which of the following work-center logs is a
required log?
1.
Pass down log
2.
Trouble log
3.
PMS accountability log
4.
Tool check-out log
1-7.
Who will normally update your work-center
supply log?
1.
Work-center supervisor
2.
Repair parts petty officer
3.
Chief petty officer
4.
Division officer
1-8.
How frequently is your work-center PMS
accountability log normally inspected?
1.
Daily
2.
Weekly
3.
Monthly
4.
Quarterly
1-9.
For which of the following purposes may the
commanding officer authorize the use of
laminated danger tags?
1.
After-hours trouble shooting
2.
Emergency maintenance after1600
3.
Routine maintenance during working
hours
4.
Routine maintenance after working hours
1-10.
Who is required to audit your work-center’s
laminated danger tags on a daily basis?
1.
Work-center supervisor
2.
Leading petty officer
3.
Division officer
4.
Department head
1-11.
Which of the following publications give(s)
specific instructions for tag out requirements?
1.
Your ship’s instructions
2.
The 3-M manual
3.
OPNAVINST 5100.19 series
4.
All of the above
1-12.
Which of the following logs contains your
weapon system’s baseline data?
1.
Work-center pass down log
2.
Equipment report log
3.
Smooth log
4.
Tag-out log
1
Textbook Assignment: “General Administration,” chapter 1, pages 1-1 through 1-6; “Technical Administration,”
chapter 2, pages 2-1 through 2-15; and “Electronics Safety,” pages 3-1 through 3-8.
