2-60. When you keeping the radio set tuned to output maximum power, it causes which of the following problems? 1  . 2. 3 . 4. Increases  RFI/EMI  on  the transmitting unit only Increases receive data errors on receiving units by saturating the data terminal sets only Increases  RFI/EMI  on  the transmitting unit and increases receive data errors by DTS saturation Decreases RFI/EMI on the receiving units 2-61. When the NCS enters dummy PUs, which of the following net conditions will exist, if any? 1.  Net  efficiency  increases 2.  Netcycle  time  decreases 3.   Netcycle   time   increases 4.  None,  dummy  PUs  have  no  effect on  the  net 2-62. What following NCS action is the most effective net management technique when a PU is having trouble maintaining  Link-11  communications? 1  . 2 . 3 . 4. Continuing normal Link-11 operations while the trouble PU Directing the PU to go to radio silence so that the PU does not respond to interrogations Directing all units to change from a HF frequency to an UHF frequency Removing the troubled PU from the polling sequence until the problem is corrected and the troubled PU is ready to reenter the net 2-63. When you set up the DTS to run a single-station  POFA,  the  DTS  must  be configured to operate in which of the following modes? 1.   Simplex 2.   Half   duplex 3.  Full  duplex 4.   POFA   TEST   mode 2-64. When you run a single-station POFA with the radio set which of the following  equipments  is/are  NOT checked? 1.   Security   device   I/O   path 2.   Antenna   coupler 3.  DTS-to-radio  audio  lines 4.   Radio-to-DTS   audio   lines 2-65. Running  a  single-station  POFA  can assist the technician in isolating a problem in which of the following sections of the DTS? 1.  Receive  timing 2.   Doppler   correction 3.   DTS   to   antenna   interface 4.   Transmit   timing 2-66. A single-station POFA should print the interrupts in what sequence? 1.  End  of  receive,  prepare  to  transmit, prepare  to  receive 2.  Prepare  to  receive,  prepare  to transmit,  end  of  receive 3.  Prepare  to  transmit,  end  of  receive, prepare  to  receive 4.  Prepare  to  transmit,  prepare  to receive,  end  of  receive 18